gas spring

DO'S

• Do use standard gas springs rod down

• If springs are to be stored prior to use, the spring should be stored rod down to lubricate the seal

• Do try to use ball joints to help avoid side load forces. If eye (clevises) are used ensure a sloppy fit to allow lateral movement

• Do ensure that the end fittings are in line so that side load forces are not applied as a result of misalignment

• Do try to use shorter springs close to the hinge rather than long stroke springs away from the hinge

• Do provide physical stops to limit the spring’s extremes. i.e. ensure that undue force is not applied to over compress or over extend the spring

• Ensure the gas spring’s end fittings are fully screwed home

• Where ball joints are used ensure the ball stud is flush with the surface and tightened